Craftsman CompuCarve 133.217540 Provozní pokyny stáhnout pdf (Strana 84)

CarveWright Designer Software Manual

Selecting the Pattern Bit

Every pattern on a board is carved using the same bit, generally a 1/8 or 1/16 inch ne detail bit. The bit used to

carve patterns on the board may be set through the Board Settings dialog. The Board Settings can be accessed

by going to the ‘Edit’ menu and selecting ‘Board Settings’. ‘Select Pattern Bit’ option is on the ‘Pattern Bit’ tab.

The ‘OK’ button will conrm the selection and the ‘Cancel’ button will close the Board Settings dialog without

making any changes.

Figure 9�2� Board Settings Dialog

Bit Optimization

A nely detailed pattern may be distorted due to the width of the router bit cutting away more than is desired

while carving the pattern. Bit optimization provides a method to solve this problem. With bit optimization

enabled, the pattern is modied in order to minimize the amount of the pattern that will be lost due to the size of

the bit.

To enable bit optimization, select ‘Bit Optimization’ from the ‘Carving’ menu, Carving toolbar or context menu,

and then select the desired bit optimization level from the ‘Bit Optimization’ sub-menu.

Figure 9�3� Bit Optimization Icon

Bit optimization may require a considerable amount of processor time. Waiting to turn on bit

optimization until initial layout is complete can help speed up project design.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 218 219

Žádné komentáře

Craftsman CompuCarve 133.217540 Provozní pokyny Strana 84