Craftsman 486.24494 Uživatelský manuál stáhnout pdf (Strana 5)

ASSEMBLING THE SPREADER

• Assemble the tongue to the hopper as shown in

figure 1 using two 1/4" x 5/8=hex bolts and 1/4"

hex nuts. Do not tighten yet.

F|GURE 1

Attach the hopper brace to the hopper usingtwo

1/4" x 5/8" hex bolts, one 1/4" flat washer and two

1/4" hex nutS. Do not tighten yet. See figure 2.

Place the end of the hitch bracket (two holes) down

through the slot in the tongue. Attach the hopper

brace to the top of the tongue and the hitch bracket

to the bottom using one 3/8" x 1" hex bolt, 3/8" lock

washer and 3/8" hex lock nut. Tighten all bolts

assembled so far. See figure 2,

1/4" FLAT WASHER

(ONE ONLY)

FIGURE 2

3/8" LOCK

WASHER

3/8" HEX

LOCKNUT _

NUT HOPPER

BRACE

3/8"X1"

H_ BOLT

HITCH

BRACKET

Assemble one end of a tongue brace to the side of

the tongue using two 1/4" x 5/8" hex bolts and 1/4"

hex nuts. Do not tighten yet. See figure 3.

Assemble the other end of the tongue brace to the

triangular plate on the end of the spreader. Use a

1/4" hex bolt and 1/4" hex nut in the front hole of

the plate. Use a 1/4" hex bolt, 1/4" flat washer and

1/4" hex nut in the rear he_e, with the belt and

washer assembled on the inside of the hopper as

shown in figure 3, Do not tighten yet.

Repeat steps 5 and 6 to attach the second tongue

brace to the other end of the spreader and then

tighten all loose bolts.

1/4" FLAT WASHER_

(One per side) _ _ _ .

1/4 HE.X NU.T_-/-- HEX BOL't _.--///_._

To. E SOLT /

1/4" HE)( NUT

FIGURE 3

1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře

Craftsman 486.24494 Uživatelský manuál Strana 5

Komentáře k této Příručce

Související produkty a manuály pro Rozmetadlo Craftsman 486.24494