Craftsman CompuCarve 133.217540 Návod k obsluze stáhnout pdf (Strana 16)

Sears, Roebuck and Co. CompuCarve™ System (Rev 1.18) 04/23/07

Operation

Using the CompuCarve System

Before the CompuCarve can begin to function, the CarveWright memory

card must be installed. With the power off, push the memory card gently

into the memory card slot until it stops, making sure the label is up.

WARNING: Never remove the memory card from the machine

while it is on. Doing so can result in damage to the workpiece.

At any point during operation the CompuCarve machine can be

stopped by pressing the STOP key or by lifting the cover. If desired

the machine can be restarted by closing the cover and pressing

ENTER. The machine will resume cutting at the point where it was

stopped. Pressing the STOP button a second time will abort the

project so be careful when restarting.

Note for reading this manual: all keypad button selections will be

shown in bold and all LCD menu displays will be shown in italics.

Once the CarveWright memory card is installed, the machine can be

turned on with the power switch. Look at the LCD display, and rotate the

contrast control knob (located directly under the keypad) until the display

is readable from a comfortable angle.

The CompuCarve may be used in two complementary ways. First, and

most powerfully, the CompuCarve can carve intricate patterns and

designs created through the CarveWright design software running on a

computer. Second, there are built-in woodworking functions on board the

machine including:

• Rip Cuts and Cross Cuts

• Edge Jointing

• End Squaring

• Miter Cuts

• Bevel Cuts

• Edge Routing

These built-in functions are generally used to prepare a board for carving,

but they can be used to dress up a board if desired. (See section titled

Built-In Functions below.)

Creating Projects with the CarveWright™ Software

Discussion of the usage of the CarveWright design software is beyond the

scope of this manual and is covered separately. Please refer to the

CarveWright software help items included on the software CD.

It is advisable to have a supply of suitably sized scrap wood on

hand for trial cuts. Very often it is desirable to tweak details in a

design before doing a final carving.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 45 46

Žádné komentáře

Craftsman CompuCarve 133.217540 Návod k obsluze Strana 16