Craftsman CompuCarve 133.217540 Návod k obsluze stáhnout pdf (Strana 37)

Sears, Roebuck and Co. CompuCarve™ System (Rev 1.18) 04/23/07

General Tips and Helpful Reminders

MAXIMUM CUT DEPTH for any operation is 1.0 inch. The machine will

not allow deeper operations.

ALL MOTORS ARE DISABLED when the front safety cover is open.

The cover must be closed before the machine can proceed.

WHEN LOADING THE WORKPIECE, there are several critical checks to

make before proceeding.

o Do not attempt to load a workpiece that has a significant taper to the

sides. A tapered workpiece will bind between the sliding plate and the

squaring plate and will damage the traction drive.

o Do not attempt to load a workpiece that varies in thickness by more

than 1/16” along its entire length. Using a workpiece with a larger

thickness variation than 1/16” can lead to damage to the machine.

MAKE SURE THAT THE HEAD LOCKING LEVER IS RELEASED after

finishing carving. If the locking lever is not released the head will not

move up and down. The lever is in the locked position if it is rotated out

from the face of the machine. It is in the released position if it is flush to

the front face of the head.

TO AVOID SNIPE, use outfeed roller stands for long workpieces. Any

workpiece over 3 feet long will require that additional stand-alone outfeed

rollers be used to support the workpiece. Make sure the rollers are

adjusted properly to avoid letting the workpiece sag or rise up against the

upper rollers. Any uneven transition going on and off the rollers will be

seen in the finished carving, similar to snipe effects from a power planer.

WHEN CARVING LARGE PIECES, the CompuCarve machine should

be secured to the bench for stability. Holes are provided in the four

corners to bolt the machine down.

USE ONLY QUALITY TOOLS. Be sure cutters are sharp and not

damaged. Use only approved cutting bits.

FOR BEST CARVING RESULTS

o Always make sure the Board Tracking Sensor that contacts the

bottom of the workpiece has a smooth, even surface to follow. This

means that the bottom edge area of the workpiece adjacent to the

squaring plate is clean, smooth, and even for a width of at least 1/4

inch along the full length of the workpiece.

o Keep all vector cuts at lease 3/4" away from the left edge. This will

assure that the Board Tracking Sensor will remain in contact with the

board at all times.

o Warped, bowed, or cupped pieces should be used only if this

condition is minor and if the Board Tracking Sensor can follow it. A

workpiece with slight cups or bows should be inserted curve down.

o Avoid creating very thin features that protrude from the surface of the

carving. Very thin features that are raised are prone to chipping.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 45 46

Komentáře k této Příručce

Žádné komentáře

Craftsman CompuCarve 133.217540 Návod k obsluze Strana 37

Komentáře k této Příručce

Související produkty a manuály pro Elektrické nářadí Craftsman CompuCarve 133.217540