
Sears, Roebuck and Co. CompuCarve™ System (Rev 1.18) 04/23/07
30
Proper Bit Installation Into the Bit Adapter
1/2" Adapter Style – Assemble the bit so that the face of the adapter is 1/8” from the bottom of the cutting surface.
A B C
(Correct) (Incorrect) (Incorrect)
1/4" Adapter Style –
Like the 1/2" style, assemble the bit so that the face of the adapter is 1/8” from the bottom of
the cutting surface. The only exception to this is the 1/4" Ball Nose bit (BBN25) and solid carbide bits. This BBN25 bit
must be assembled as shown in Figure 25.
FIGURE 24: CORRECT BIT ASSEMBLY IS SHOWN IN EXAMPLE A. THE BIT
IS
TOO LOW IN EXAMPLE B AND TWO HIGH IN EXAMPLE C.
F
IGURE 25: CORRECT BIT ASSEMBLY
POSITION FOR ¼” BALL NOSE BIT
Komentáře k této Příručce